[. . . ] Tubes* 20A Hard flat floors nozzle* 20B Hard flat floors nozzle with removable brush* a - use on hard flat floors with crevices b - use on fragile hard flat floors 21. Unpacking • Unpack your appliance, keep your warranty card and read the instructions for use carefully before using your appliance for the first time. € Your vacuum cleaner is an electrical device: it must be used under normal conditions of use. € Check that the power voltage for your vacuum cleaner corresponds to that of your mains installation. [. . . ] € If your vacuum cleaner is equipped with the telescopic tube* (18) : push the adjustment knob forward, pull the desired tube length out then release the button to lock - fig. € Fit the desired accessory to the end of the tube: Choose the right accessory - for rugs and carpets: use the 2-position nozzle (21) on carpet position (retracted brush) or the turbobrush* (fibres and animal hairs). - for hard flat floors and hard flat floors with crevices (such as tiled floors): use the 2position nozzle (21) on hard floor position (brush extended), or for better results, use the hard flat floor nozzle* (20B. - for fragile hard flat floors, such as parquet, it is recommended to use the hard flat floor nozzle (20A) or (20B. This nozzle allows you to optimise the dust-collection performance of your appliance on hard flat floors with crevices. - For corners and areas which are difficult to reach: use the slot tool attachment convertible into a brush* (23) in the flat tool attachment position. - For upholstery and delicate surfaces : use the crevice tool convertible into brush* (23) or the upholstery nozzle* (22) or the brush integrated to the nozzle (17). IMPORTANT Always switch off and unplug your vacuum cleaner before changing the accessories. € Unwind the power cord completely, plug your vacuum cleaner in - fig. € Set the suction power: - using the electronic power regulator (3) : turn the switch on the electronic regulator : to set the suction power: towards maximum position for floors and minimum position for furniture and fragile fabrics - fig. - with the mechanical power regulator on the grip: open the slider on the grip to manually reduce suction power, e. € Ensure that the HEPA filter cassette is completely dry before replacing it. € Replace the washable HEPA filter cassette* (14b) in its housing- fig. *Depending on model: equipment specific to certain models or optional accessories. 13 EN CLEANING AND MAINTENANCE • Re-fit the grey foam filter (14e) to the microfilter 5. € Dispose of the microfilter (14d) in a waste bin and replace it with a new Microfilter. € Wash the grey foam filter (14e) with warm soapy water (mild detergent). Caution: Make sure that the grey foam filter is completely dry before putting it back in place. € Check that the microfilter cassette * (14c) is fitted correctly before re-closing the lid (9). Clean the vacuum cleaner • Clean the housing of the vacuum cleaner with a soft and humid rag and let dry. TROUBLESHOOTING Important: As soon as your vacuum cleaner stops performing efficiently, and before making any checks, stop it by pressing on the On/Off pedal. € Repairs should only be performed by specialists using original spare parts. [. . . ] If your vacuum cleaner does not start • The appliance is not powered: make sure the appliance is properly connected. If your vacuum cleaner does not suck • An accessory or the hose is blocked: unblock the accessory or hose. € The lid is not properly closed: check the position of the bag and bag support (15) and close the lid. If the bag full light stays red • The bag is saturated: replace the paper bag* or empty the textile bag*. [. . . ]